WireEnd

Wiring Overview The Wiring Layer in the VEC provides modeling concepts to define the physical realization of electrological connections from the System Schematic Layer. In the VEC, the same modeling concepts are use for this layer as for the mapping of a concrete wiring harness in the model.

This Implementation Guideline covers the various aspects of a correct wire representation in the VEC for different scenarios and variants of wires. It covers both multi cores and single cores.

Instances of Wires The diagram shows the mapping between the part master data of a wire (partly displayed on the left side) and the instance specific information (displayed on the right side).

Instances of Wires The diagram shows the mapping between the part master data of a wire (partly displayed on the left side) and the instance specific information (displayed on the right side).

Instances of Wires The diagram shows the mapping between the part master data of a wire (partly displayed on the left side) and the instance specific information (displayed on the right side).

Wiring Specification The VEC model breaks down the information that is usually included on an electrical system wiring plan into three aspects: part usage information, contacting information and mating information.

Contacting Specification A ContactingSpecification is used to describe contacting information in several uses cases: It can be used to describe both the more abstract contacting information which is contained on an electrical system wiring plan and the very concrete contacting of an assembly / module/ harness configuration or even a 150% harness description.

Contacting Specification A ContactingSpecification is used to describe contacting information in several uses cases: It can be used to describe both the more abstract contacting information which is contained on an electrical system wiring plan and the very concrete contacting of an assembly / module/ harness configuration or even a 150% harness description.

Contacting Specification A ContactingSpecification is used to describe contacting information in several uses cases: It can be used to describe both the more abstract contacting information which is contained on an electrical system wiring plan and the very concrete contacting of an assembly / module/ harness configuration or even a 150% harness description.

Instances of Wires The diagram shows the mapping between the part master data of a wire (partly displayed on the left side) and the instance specific information (displayed on the right side).