CavitySpecification
Note: There is a newer version of this specification see VEC 2.1.0
Specification for the definition of cavities.
General Information
| Attribute | Value |
|---|---|
| Owner | electrical_parts |
| Applied Stereotype | |
| Base Classifier | Specification |
| Is Abstract | false |
| Derived Classifiers |
Attributes
| Name | Type | Mult. | Description | Owning Classifier |
|---|---|---|---|---|
| identification | String | 1 | Specifies a unique identification of the specification. The identification is guaranteed to be unique within the document containing the specification. For all VEC-documents a Specification-instance can be trusted to be identical if the DocumentVersion-instance is the same (see DocumentVersion) and the identification of the Specification is the same. |
Specification |
| description | AbstractLocalizedString | 0..* | Specifies additional, human readable information about the specification. |
Specification |
| angle | NumericalValue | 0..2 | Specifies the angle against two planes of the connector housing a terminal used in this cavity can be buckled. |
CavitySpecification |
| cavityDesign | String | 0..1 |
Deprecated [for removal since V[]]: [] Deprecated (since Version 1.1.4): This attribute has been marked as deprecated, as it has been replaced by the more meaningful mechanism with TerminalTypes. |
CavitySpecification |
| geometry | CavityGeometry | 0..1 | Defines the geometry of a cavity in the sealing area (crimp end). |
CavitySpecification |
| cavityDimension | Size | 0..1 | Specifies the dimension of the cavity in the sealing area of the cavity (crimp end), not in the contacting area (box end). The Height of a cavity is defined as the dimension of cavity in the direction of the primary locking. The Width is the dimension orthogonal to the Height. For cavities with Geometry = Circular the Size.Width shall be equal to Size.Height. |
CavitySpecification |
| minWireElementOutsideDiameter | NumericalValue | 0..1 | Specifies the minimum diameter a wire is allowed to have to fit into the cavity. This definition is necessary, since wires that are too small might cause movements and in acceptable torsion forces on terminals. |
CavitySpecification |
| maxWireElementOutsideDiameter | NumericalValue | 0..1 | Specifies the maximum diameter a wire is allowed to have to fit into the cavity. |
CavitySpecification |
| primaryLockingType | PrimaryLockingType | 0..1 | Specifies if the cavity has a primary locking and of what type it is. |
CavitySpecification |
| sealable | Boolean | 0..1 | Specifies if the cavity is sealable. |
CavitySpecification |
| compatibleTerminalType | TerminalType | 0..* | Defines a list of terminal types that are compatible to this CavitySpecification. |
CavitySpecification |
| cavitySealingLength | NumericalValue | 0..1 | Defines the length of the sealing area in the cavity. | CavitySpecification |
Incoming Relations
| This End | Other End | General | |||||
|---|---|---|---|---|---|---|---|
| Role | Mult. | Agg. | Unique | Ordered | Type | Mult. | Description |
| cavitySpecification | 0..1 | N | Y | N | Cavity | 0..* | References the CavitySpecification that is satisfied by the cavity. |